How To Remove Plastic Window Shutters

Exterior Shutters

Shipping To: Toll Free: 1-800-734-6268

Removing Exterior Vinyl Shutters that are Installed with Shutter-Loks

Shutter-Loks (sometimes spelled "shutter locks" and often referred to equally easy-loks, shutter plugs, plastic nails, or reverse spinous button locks) are designed for a permanent shutter installation. However, it is still possible to remove decorative exterior vinyl shutters when doing maintenance (such equally outside painting or installing new siding) on your home. You can remove the window shutters, just installing them again volition crave y'all to purchase new Shutter-Loks. Proceed this in mind before you lot take them downwards, considering Shutter-Loks generally cannot be found in local stores.

Do not effort to pull the Shutter-Lok out of the wall, as you lot will most probable impairment the surface of your exterior vinyl shutters. To remove the exterior decorative shutters, you lot will demand the following:

A small chisel with a sharpened edge
A hammer
Silicone or caulking compound
A diagonal cutter
An electric drill with a 1/4" drill bit

Turn the chisel so the sharp border is facing away from the surface of the house and slide information technology behind the shutter until information technology rests against the Shutter-Lok. Apply a hammer to give the handle of the chisel a sharp rap and the chisel volition cutting through the Shutter-Lok.

After you lot have cut through all of the Shutter-Loks, take the shuttter down and gear up it advisedly on the basis. Utilize a diagonal cutter to shear the remaining piece of the Shutter-Lok from the wall so information technology is affluent with the surface. Next, drill out the Shutter-Lok using a 1/4" or slightly smaller drill bit. Do not leave the Shutter-Lok within of the wall (unless it falls inside the cavity) considering moisture tin leak in and information technology will showtime to rot.

At present, if yous plan to leave the window shutters off of your home, you should fill the pigsty in with caulking chemical compound and smoothen it off so information technology is level with the surface and you can then repaint to brand the hole invisible.

If you plan to reinstall the vinyl exterior shutters after you pigment your domicile or do other maintenance, fill the hole partially with silicone to weatherproof information technology temporarily. After painting the outside of the house or doing other maintenance, y'all can redrill the hole with a 1/4" drill scrap to remove the silicone.

To reinstall your exterior shutters, rest the exterior window shutter against the surface and align information technology with the holes, then press the Shutter-Loks into the holes function style to concur the vinyl shutter in place. Utilize a hammer to very gently tap the Shutter-Lok until it is flush with the surface of the exterior window shutter. Exercise not keep tapping, equally this will brand the shutter first to dimple and you will need to purchase new Shutter-Loks and start over because there is no way to pull them back out. You should go out the Shutter-Loks just slightly loose to permit for expansion and wrinkle.

Click to verify ShutterContractor.com BBB accreditation and to see a BBB report. BizRate Customer Certified (GOLD) Site - Shutter Contractor.com Reviews at Bizrate